The ADN 409 has been developed as a CNC control system for operation with a directional proportional valve
The assembly consists of two modules, MD1 is the basic module (equivalent to the ADN 402), and MD14 is the CNC expansion module
Equipped with an SSI interface for operation with an absolute position encoder, such as absolute shaft encoders or Temposonic, for example
A pulse generator interface which permits incremental position measurement has also been included
Equipped with its own signal processor, which has a processing speed of 40MIPS
Equipped with the CAN bus
Four inputs and four outputs
Profibus DP is available
All settings are effected using the ADN configurator via an RS232 interface linked to a PC or laptop computer

Type		CNC control system
Use		Operation with a directional proportional valve
Supply voltage		24V DC, nominal (22...28V) DC
Inputs		10 opto-decoupled
Outputs		5 x 24V/100mA
Measuring sockets		The output current of the A and B magnets can be measured at 1V/A on Measuring Sockets M1 and M2
Temperature range		-20°C...+60°C
Controller setting range		1 to 32000 for P, I, DT1
Sensor modules for MD1		±10V, 12mA ±8mA, 4–20mA, 0–10V, 7.5V ±4V
For mer informasjon		Klikk her --- Datablad