The AN419 servo amplifier module is intended for the control of single magnet proportional valves.
Snap-on housing enables the AN419 module to be mounted on normal carrier rails in control cabinets
Electrical connections are via a terminal strip and a flat connector (enable input)
The output stage is a duplex output stage with high-dynamic response and rapid deexcitation. These design features ensure rapid switch-off of the magnet coil (approx. 4...6 ms)
Multi-turn resistors allow the adjustment of volumetric flow amplification, pressure <br>amplification and Imin jump

Type		Servo amplifier
Use		Control of single magnet proportional valves
Supply voltage		24V DC (22...32 V DC)
Temperature range		0...+50°C
Output stage		Duplex output stage with high dynamic response and rapid deexcitation (approx. 4...6 ms)
PWM frequency		Approx. 5kHz
Dither		Approx .150 Hz factory setting Amplitude adjustable on the 'Dither' potentiometer within a range of approx. 0 - 10% of the nominal current setting
Input (various input modules are available)		0...10V (differential input) 4...20mA (differential input)
Measuring sockets		Current: valve current: 1V/A (10%) Command: setpoint signal (0...10V)
For mer informasjon		Klikk her --- Datablad